
From AED 400
Brand care
Ferrari detailing treats the paint, exposed carbon fibre and hand-finished interiors of each model with the right products. We care for Ferrari cars at our Mussafah centre.

Mon to Sat 09:00 to 22:00, Sun 09:00 to 19:00
Popular services

From AED 400

From AED 1,250 + VAT

From AED 650
Models
Why us
Know before you book
Ferrari detailing in Abu Dhabi starts with the paint, since Ferrari offers a huge range of colours, some made for one model only. We look after these cars in Mussafah, along with their exposed carbon and hand-trimmed cabins.
Nero Purosangue shows why this matters. Its pigments throw strong red reflections in certain light, and a shade like that is slow and costly to match after a repair.
Every Ferrari shares careful paint care, but each model adds its own details to watch.
Ferrari paint deserves caution because many colours are rare, and every correction removes a little clear coat. You cannot put that layer back once it has been polished away.
The Purosangue alone came with launch colours made just for it. Matching a common black is routine work, but a pigment with red reflections needs test panels and patience.
For that reason, damage prevention beats repair. Paint protection film takes stone chips on the nose and sills, and the original paint stays untouched underneath.
When paint does need work, light correction is the rule. Remove only the scratch, keep as much factory finish as possible, then protect it.
Many Ferraris show carbon fibre on the roof, bumpers or cabin trim, always under a clear finish. The Purosangue has a carbon roof as standard, and Ferrari says it weighs 20% less than an aluminium roof with soundproofing.
Owners can swap that roof for a glass one that tints electrically. Inside, an optional carbon weave even includes very fine copper wire.
That clear finish scratches and fades like paint. Gentle washing, quick drying and a coating keep the weave looking deep under the summer sun. If it has already gone cloudy, our carbon fiber team can assess repair or replacement.
A Ferrari cabin is cleaned one material at a time, because leather, Alcantara and recycled fabrics react differently. The 296 GTS uses Italian leather on its seats and trim.
The Purosangue goes further with recycled materials. Its Alcantara option contains 68% post-consumer recycled polyester, the roof lining is recycled polyester, and the carpet uses nylon recovered from fishing nets.
Owners can even replace the floor carpet with a tough fabric used in military uniforms. Ferrari also offers a dark brown semi-aniline leather, which has only a light surface finish and picks up stains quickly.
An interior detail treats each surface with its own product and very little water. If a panel is torn, car upholstery specialists can retrim it.
The paint and cabin work stay the same, but water stays away from the hybrid hardware. On the 296 GTS, the fuel filler and charge covers sit in sculpted panels beside the engine cover. Never aim a jet at them.
The 7.45 kWh battery sits on the floor behind the seats. It is not part of detailing, and anything near the charging system is cleaned by hand.
The folding roof brings its own routine. Its two sections stow over the engine, so let them dry fully and wipe grit from the seals before you lower the top.
At the rear, an active spoiler sits in the bumper between the tail lights. Clean its edges by hand instead of blasting them with a pressure lance.
In this region, heat, sand and fast motorway driving do most of the harm to a Ferrari. Each row below links a typical problem to the service that usually sorts it out.
| Common issue in the UAE | What usually fixes it |
|---|---|
| Chips on the nose, splitter and bonnet edge | Clear film across the front end |
| Cloudy clear finish on the carbon roof or trim | Restoring or replacing parts through carbon fiber work |
| Fine scratches in a model-specific colour | Light correction with a car polish |
| Kerb marks on diamond-cut forged wheels | Rim repair to refinish the face |
| Flattened Alcantara on seats and the wheel rim | A gentle cabin detail with minimal water |
| Sand that clings after a desert drive | A ceramic coating that lets it rinse away |
A common plan is film on the front end and a coating everywhere else. That pairing keeps a rare colour safe and makes routine washing quicker.
Many owners choose to fit clear film before the car covers any real distance. The nose, bonnet and mirrors collect chips quickly at motorway speed.
Paint repairs are possible, but special and personalised colours are hard to match exactly. Protecting the original paint avoids that problem.
Carbon parts are washed like paint, with a soft mitt and gentle shampoo. Abrasive polishes are kept away from the clear coat that protects the weave.
Only on a clean car, and only a soft, breathable cover. A cover pulled over dusty paint rubs grit into the clear coat.
The bright face is machined metal sealed under a thin clear layer. Strong acid products can cloud that layer, so a mild cleaner and a soft brush are safer.